Guías de Modelos Diecast
American Diorama Car Meet 2 Figurine I 76389: 1:24 Display Guide
American Diorama item 76389 is Car Meet 2 Figurine I, a hand-painted polyresin figure designed for 1:24 car-meet, garage and street-display scenes. The fixed-pose figure stands approximately three inches tall and is supplied in a blister package.
The vehicle shown in lifestyle photographs is not included. This listing contains one figure only.
American Diorama 76389 at a glance
- Maker: American Diorama
- Series: Car Meet 2
- Figure: I
- Scale: 1:24
- Material: Hand-painted polyresin
- Pose: Fixed
- Approximate height: 3 inches
- Packaging: Blister pack
- Package contents: One figure; no car
- Manufacturer item: 76389
Why a single figure changes a car display
A row of 1:24 cars shows vehicles; a properly placed figure creates an event. Figurine I can establish scale, suggest conversation or direct attention toward a featured car without requiring a large diorama.
The figure’s fixed stance should guide placement. Rotate the figure and vehicle together until the body direction makes sense. Avoid a pose where the figure appears to look away from the entire scene.
Three ways to use Figurine I
Car-meet conversation
Place the figure beside a front fender or open door with enough space for another figure. Two figures should face one another or share a clear focal vehicle.
Show-car presentation
Position Figurine I slightly behind the featured car so the vehicle remains the main subject. A simple platform and banner can create a clean event display.
Garage or street scene
Use a 1:24 garage wall, curb or parking stripe to establish context. Keep props sparse so the figure and car do not become lost in clutter.
Matching the figure to 1:24 scale
At approximately three inches tall, Figurine I is intended for 1:24 buildings, vehicles and accessories. A 1:18 car will usually appear too large, while a 1:32 car can look undersized. Physical measurements are more reliable than visual guesses from package photographs.
Leave a small gap between the figure and painted bodywork. Polyresin and hand-painted details can rub against a model if the two pieces remain in contact.
Handling hand-painted polyresin
- Lift by the torso and legs rather than fingers, clothing edges or hair.
- Do not bend the arms or change the fixed pose.
- Work over a padded surface in case the figure tips.
- Dust with a soft brush or low-pressure air.
- Avoid direct sunlight and high-temperature display lamps.
- Keep the blister package for transport and storage.
Keeping the figure stable
Test the stance on a flat display base before permanent installation. A small amount of removable museum putty beneath the feet can improve stability after it has been tested on the base material.
For a portable car-meet scene, removable mounting is preferable to permanent glue. It allows the figure to be repositioned when the featured vehicle changes.
Arrival checklist
- Confirm item 76389 and Car Meet 2 Figurine I.
- Verify that the package contains one figure and no vehicle.
- Inspect the face, hands, clothing edges and feet through the blister.
- Check the hand-painted finish for shipping rubs.
- Place the figure on a level surface and confirm a stable stance.
- Photograph the pose from the intended viewing angle.
- Save the original blister for future storage.
Who this figure suits
American Diorama 76389 is a strong fit for 1:24 car meets, showrooms, custom-car displays and builders who want a ready-painted figure without assembling a kit. It can be used alone or combined with other Car Meet 2 figures to create a larger crowd.
Final identification check
The exact release is American Diorama Car Meet 2 Figurine I, an approximately three-inch hand-painted polyresin figure for 1:24 displays, item 76389.
View American Diorama Car Meet 2 Figurine I
Browse more American Diorama figures and 1:24 cars, trucks and model kits.
