Collector Guides

Display Cases for BRP Models: Measure Roadsters, ATVs and Mavericks

Representative current product image for Display Cases for BRP Models: Measure Roadsters, ATVs and Mavericks

Choose a display case by usable internal dimensions and the complete model arrangement, not a generic scale label. A roadster's wide front wheels, an ATV rider and a Maverick roof rack can each become the part that prevents a fit.

Compare BRP models for your display space

Product image: Can-Am Ryker Rally Sand Storm/Black – BRP Models 1:32
Current referenced product: Can-Am Ryker Rally Sand Storm/Black – BRP Models 1:32.

Small roadsters still need width

The 1:32 Ryker Rally 60015 is listed at approximately 3 inches long, 2 wide and 1.5 high. A narrow slot suitable for a conventional small motorcycle may not accommodate its two-inch front-wheel spread.

Measure the widest projections rather than only the seat or central body. The case's wall thickness and raised base edges reduce usable space, so exterior case dimensions are not a fit guarantee.

ATV riders create a separate height check

The Outlander XT-P 60006 is approximately 2.75 by 1.5 by 1.5 inches in its listing and includes a removable driver. Confirm the total height with the figure installed instead of assuming the catalog measurement establishes clearance above the helmet.

A parked ATV with its rider removed and an occupied ATV are two different display arrangements. Measure the one you actually intend to use.

Side-by-side roofs and cages can be the limiting point

The Maverick Trail 60027 is approximately 3.75 by 1.5 by 2.25 inches. The Defender XT HD9 60032 is approximately 4 by 1.875 by 2.5 inches.

A cover that fits the shorter, narrower Trail does not automatically fit the Defender. Leave room to lift the cover clear without touching a cage, roof or mirror.

Product image: Can-Am Outlander XT-P 1000R Gray/Yellow with Driver – BRP 1:32
Current referenced product: Can-Am Outlander XT-P 1000R Gray/Yellow with Driver – BRP 1:32.

Large 1:12 models need a different enclosure

The 1:12 Ryker 68001 is listed at approximately 8 by 5.25 by 4 inches. The black Maverick 68002 is approximately 11.25 by 5.25 by 5.25 inches.

The roof-rack Maverick 68004 has the same listed length and width but a 5.75-inch height. A case with only five inches of usable height is clearly unsuitable for that listed model envelope.

Finish with the actual arrangement

Include any platform, nameplate or separate figure in the measurement. A boxed display requires retail-package dimensions, not merely the model dimensions. Do not rely on removing an unconfirmed detachable part to make a tight fit work.

The measurements here are approximate listing data, not physical case-fit tests. Choose the model, measure the intended display and confirm the enclosure's usable space before ordering. Review the vehicles in the BRP Models Can-Am collection.

Make the final choice from the exact listing

Use the article’s comparison points to narrow the category, then verify the exact subject, scale, finish, condition and included components on the current product page. Product names can look similar even when packaging, accessories or dimensions differ. Save the manufacturer item number when available so you can compare the same release rather than two adjacent versions.

Plan where the model will be displayed and how it connects to the rest of the collection before ordering. The collector guides hub provides related scale, identification and display guidance.